Front Indirect Actuation Assembly

Subteam: SuspensionSubsystem: RodsAssembly: Front Indirect Actuation AssemblyCars: CR21, CR22, CR25, CR26I

Purpose

Assembly line covering the front bellcrank, pullrod and their hardware.

Function

Indirect actuation means the damper is not on the wheel; the bellcrank sits between them. Groups the bellcrank plates, bung, nut, spacers, support plate and the pullrod. Design Philosophies and Processes: Inherited from the Bellcranks subsystem design process: 1. Take the wheel rate target from kinematics; the bellcrank is named by it (CR26I front is the 150 lb/in wheel rate crank, rear the 200 lb/in). 2. Set the architecture: connection points, pivot location, double or single shear. 3. Size the pivot for shear from the vector sum of rod and damper loads. 4. Run single-plate FEA for deflection first, then stress. CR26I rear single plate at 0.19 in gave FoS 3.54. 5. Calculate the wheel rate change that the measured deflection produces, and confirm it is inside tolerance. 6. Fit and validate the damper position sensor.

Reoccuring issues

None recorded. This part has no entry in Knowledge_Transfer/Issue Logging/Fault Vault.xlsx, in either Issue Log.xlsx, in CR22/Issue Tracking/Shakedown 7-15-23.xlsx, or in any design review issue list found in CrimsonStorage or Box.

Still to document

Nothing in CrimsonStorage covers these yet.

Design Process — How it is designed and deemed effective at its purpose and function
Design Constraints — What held back the design whether it be location, time, materials etc
Analysis — How you get quantitative, predictive information on the part
Manufacturing Process — How it is assembled in detail from start to finish
Full Material List — Everything used to build this part (Best if actual numbers are used to show how it evolves year to year)
Improvements — Improvements for this generation
Properties — Size, weight, mass, charge, thermal properties, anything else relevant