CR21 naming for the rear ARB drop link tube.
A tube in tension and compression. Buckling governs in compression, so sizing runs against critical buckling load before it runs against yield.
No part-specific design process is documented. The ARB subsystem design process applies: 1. Take the roll rate targets and the LLTD range from vehicle dynamics. 2. Size the torsion bar. CR26I: AISI 4130, 0.5 in OD, 0.33 in ID, 68.12 lb-in/deg torsional stiffness, contributing 1160 lb-in/deg (96.7 lb-ft/deg) to roll rate at nominal. 3. Design the blade and set the drop link positions. Five settings give blade lengths from 4.43 in to 5.57 in and roll rate contributions from 113.8 down to 72 lb-ft/deg. 4. FEA the blade at each setting to confirm deflection and the resulting change in roll rate contribution (1.24% to 1.34% across the range). 5. Design retention: a machined square boss and bore to minimise backlash, a threaded stud for blade retention, and a transition-fit needle bearing for bar mounting. 6. Confirm the resulting LLTD range on the car.
Cut to length, then welded or bonded to its end inserts.
Steel.
None recorded. This part has no entry in Knowledge_Transfer/Issue Logging/Fault Vault.xlsx, in either Issue Log.xlsx, in CR22/Issue Tracking/Shakedown 7-15-23.xlsx, or in any design review issue list found in CrimsonStorage or Box.
Nothing in CrimsonStorage covers these yet.