Illuminate under braking as the rules require, using as little power as possible.
A team-designed and manufactured PCB in a housing, mounted at the rear of the car and triggered by the brake pressure signal.
The team has always designed and manufactured its own brake light specifically to reduce power consumption against an off-the-shelf unit. CR22's design was given to a younger member as a development project and made in the shape of a Script A.
Rules define the required size, colour, brightness and position.
Board manufactured externally, populated and bench tested in house before it goes on the car.
Custom PCB, LEDs, 3D printed or machined housing.
None recorded. This part has no entry in Knowledge_Transfer/Issue Logging/Fault Vault.xlsx, in either Issue Log.xlsx, in CR22/Issue Tracking/Shakedown 7-15-23.xlsx, or in any design review issue list found in CrimsonStorage or Box.
The Script A shape may increase power used; the plan recorded was to validate whether it saves power against the old design rather than assume.
Nothing in CrimsonStorage covers these yet.