Connects the MoTeC C185 dash to its sensors and to the CAN network on CR22 and CR25.
Superseded by the DDU11 harness. The C185 was unreliable, which is what drove the change.
No part-specific design process is documented. The Electrical Harness subsystem design process applies: 1. Collect the sensor list and the datalogger assignment for each sensor. 2. Draw the harness in RapidHarness: main connectors, sensor connectors, connections, then bundles and split points. 3. Order wire early. BMRSWired lead time has run 2 weeks to 3 months and is the single highest-impact long lead item. 4. Cut and crimp terminals, assemble connectors, build service loops. 5. Twist the harness, cover with DR-25 heat shrink, test fit on the frame, then install and recover transition boots and connector boots.
Designed in RapidHarness, then cut, crimped, assembled with service loops, twisted, covered in DR-25 and test fitted on the frame before boots are installed.
M22759 tinned copper wire with Tefzel insulation, Raychem DR-25 heat shrink, Deutsch DTM/DT connectors, RT125 epoxy, Kevlar binder.
None recorded. This part has no entry in Knowledge_Transfer/Issue Logging/Fault Vault.xlsx, in either Issue Log.xlsx, in CR22/Issue Tracking/Shakedown 7-15-23.xlsx, or in any design review issue list found in CrimsonStorage or Box.
Nothing in CrimsonStorage covers these yet.