Provides the threaded mounting point for the anti-submarine belt.
An insert bonded or welded into the seat structure so the belt load goes into structure rather than into laminate.
No part-specific design process is documented. The Ergonomics subsystem design process applies: 1. Take driver body measurements and place them against the ergonomics study ranges. 2. Mold the seat insert to the driver in the car with expanding foam, then hand post-process and cover. 3. Set headrest and harness mounting to the rules and to the driver's shoulder height. 4. Run a simulator or on-track endurance stint and measure fatigue with EMG. 5. Iterate the insert shape at the identified pressure and support points.
Machined, then bonded or welded into the parent part.
Aluminium or steel insert.
None recorded. This part has no entry in Knowledge_Transfer/Issue Logging/Fault Vault.xlsx, in either Issue Log.xlsx, in CR22/Issue Tracking/Shakedown 7-15-23.xlsx, or in any design review issue list found in CrimsonStorage or Box.
Nothing in CrimsonStorage covers these yet.