Provide rearward visibility as required by the rules.
Mounted to the bodywork or roll hoop with a field of view meeting the rules requirement.
No part-specific design process is documented. The Ergonomics subsystem design process applies: 1. Take driver body measurements and place them against the ergonomics study ranges. 2. Mold the seat insert to the driver in the car with expanding foam, then hand post-process and cover. 3. Set headrest and harness mounting to the rules and to the driver's shoulder height. 4. Run a simulator or on-track endurance stint and measure fatigue with EMG. 5. Iterate the insert shape at the identified pressure and support points.
None recorded. This part has no entry in Knowledge_Transfer/Issue Logging/Fault Vault.xlsx, in either Issue Log.xlsx, in CR22/Issue Tracking/Shakedown 7-15-23.xlsx, or in any design review issue list found in CrimsonStorage or Box.
Nothing in CrimsonStorage covers these yet.