Mirror of the left front wing endplate.
Identical function, mirrored geometry. See the left endplate entry for the sweep data that justifies the fence and half-tube.
No part-specific design process is documented. The Front wing subsystem design process applies: 1. 2D CFD sweeps in ANSYS to place elements and set angle of attack cheaply. CR26E ran 153 two-element and 148 three-element sweeps for the rear wing on the same method. 2. Move promising 2D results into a 3D half-car model at 35 mph, chosen as a representative competition corner speed. 3. Iterate in the half-car model, tracking CLA, CDA, CoP and tire drag in an iteration tracker. 4. Run the best candidates in the performance map (PMAP) full-car model for yaw, roll and cornering. 5. Validate on track with constant-speed testing, tufting and Flo-Vis oil.
Waterjet from sheet, or laid up on a milled or 3D printed mold.
Same laminate schedule as the left endplate.
None recorded. This part has no entry in Knowledge_Transfer/Issue Logging/Fault Vault.xlsx, in either Issue Log.xlsx, in CR22/Issue Tracking/Shakedown 7-15-23.xlsx, or in any design review issue list found in CrimsonStorage or Box.
Nothing in CrimsonStorage covers these yet.