Sets the standoff distance between the oil cooler and its lower mount.
Positions the core so the duct and shroud can seal to it.
No part-specific design process is documented. The Lubrication subsystem design process applies: 1. Set capacity and pan geometry from the packaging envelope and the CG target. CR26I: 1.95 qt pan, 3 qt system, low-profile design lowering engine CG by 1.6 cm on the earlier revision. 2. Design the baffle and trap door layout, keeping baffle clearances tight and stiffening the mounting flange to improve gasket reliability. 3. Size the oil cooler from measured heat rejection. 4. Select the oil to meet Yamaha's specification (API SP, JASO MA2) with wet-clutch-safe additives. 5. Validate on the sloshing test tracks, logging oil pressure against lateral and longitudinal acceleration. Test 1 minimum oil pressure 30.7 psi at 7,200 rpm with 1.41 g sustained for 1 s and a 2.21 g peak; test 2 minimum 31.3 psi at 6,000 rpm with a 2.02 g peak. 6. Send an oil sample for analysis after 500+ miles of track and dyno running.
Turned on the CNC lathe, or milled where the geometry is not round.
Aluminium.
None recorded. This part has no entry in Knowledge_Transfer/Issue Logging/Fault Vault.xlsx, in either Issue Log.xlsx, in CR22/Issue Tracking/Shakedown 7-15-23.xlsx, or in any design review issue list found in CrimsonStorage or Box.
Nothing in CrimsonStorage covers these yet.