Attach the endplates to the element stack.
Carry the endplate load into the airfoil spars.
No part-specific design process is documented. The Rear Wing subsystem design process applies: 1. 2D ANSYS sweeps to optimise element positions and angles of attack for each candidate element count. 2. Verify positions in 3D and increase stack angle of attack where 2D over-predicted. 3. Run integrated half-car runs with the current undertray iteration so element interaction is captured rather than assumed. 4. Full-car yaw runs to check performance when the front stack is reduced. 5. On-track validation with tufting on both surfaces and Flo-Vis oil during constant speed and skid pad.
Milled. Mounting parts moved from waterjet to milled because the waterjet cut surface leaves stress raisers that can propagate.
Aluminium.
None recorded. This part has no entry in Knowledge_Transfer/Issue Logging/Fault Vault.xlsx, in either Issue Log.xlsx, in CR22/Issue Tracking/Shakedown 7-15-23.xlsx, or in any design review issue list found in CrimsonStorage or Box.
Nothing in CrimsonStorage covers these yet.