Alternate naming for the steering wheel connector boot.
A formed part providing a barrier, either to keep something out (debris, heat, the driver's hands) or to keep flow where it is meant to be.
No part-specific design process is documented. The Steering subsystem design process applies: 1. Kinematics sets steering geometry, Ackermann targets and rack travel. 2. Size the column and shafts for torsional stiffness and for the bearing housing that supports them. 3. Calculate static steering force from the tire and geometry, and check it against anthropometric limits. 4. Design the wheel shell around the button and switch layout and the dash sightline; prototype grips and take driver feedback. 5. Validate steering effort and Ackermann on track, using the alternate tie rod mounts to sweep setups.
Laid up on a 3D printed mold, printed directly, or formed from sheet.
Rubber or silicone boot.
None recorded. This part has no entry in Knowledge_Transfer/Issue Logging/Fault Vault.xlsx, in either Issue Log.xlsx, in CR22/Issue Tracking/Shakedown 7-15-23.xlsx, or in any design review issue list found in CrimsonStorage or Box.
Nothing in CrimsonStorage covers these yet.